You will be prompted for a PIN or custom challenge message by your 2FA provider. Use the distributed engine hostname or IP if connecting to an engine. Go to Admin > Configuration > Login > Require Two Factor for these Login Types and select one of these:Įnable 2FA on the Secret Server user by going to Admin > Users > Select a user > Edit > Two Factor and select the 2FA option.įIDO2 authentication is not supported in this version of SSH terminal.įrom any SSH terminal, connect to hostname or IP address and port, as specified in the SSH Proxy Configuration page. To enable 2FA for terminal:įollow the steps under Two-Factor Authentication to set up 2FA. SSH terminal is considered a Web service and can be used with two factor authentication (2FA). SSH Terminal Login with Two Factor Authentication The page becomes editable.Ĭlick the Maximum concurrent logins per user dropdown list and select the desired number. The Configuration page appears.Ĭlick the Edit button at the bottom of the page. To increase the maximum concurrent logins per user: For example, if Maximum concurrent logins per user is set to "1" and the user john.smith is logged into the Secret Server Web user interface, then john.smith logs into SSH terminal, his first Web session will end, and he will have to log in again to use the Web user interface. Logging in to SSH terminal counts against the number of concurrent Secret Server sessions a user is allowed. Increasing Maximum Concurrent Logins for Users If successful, you will see the terminal banner displayed, along with a list of available commands. If not provided in the SSH connect command, enter your Secret Server username and password at the Login as: prompt. Use the DE hostname or IP if connecting to an engine. Type the SSH Bind Address (description above).įrom any SSH terminal, connect to hostname or IP address and port, as specified in the SSH Proxy Configuration page. Type the Hostname and IP Address (description above). To launch secrets on non-local sites, users must connect to an SSH terminal over an engine on this site. SSH terminal can also run on each proxy-enabled distributed engine (DE) site. If you are not sure which bind IP address to use, you may use 0.0.0.0, which binds to all IPv4 interfaces on the machine.Įnabling Terminal on Secret Server Distributed Engine This should not be localhost or 127.0.0.1. The IP Address of the network adapter that the Secret Server SSH listener should bind to. In most cases, this is the same as the SSH bind address however, there are cases where the public IP or host differs from the private IP that Secret Server should bind to, such as NAT or Amazon EC2 instances. This is the public hostname or IP that the client launcher connects to. Specify the IP address for nodes (and engines) that will run SSH proxy: The resulting settings should look something like this: (optional) Click to enable Terminal Inactivity Timeout (in seconds). (optional) Customize the Terminal banner for your environment. Only SSH-based credentials can be launched in the terminal. To launch a secret via the terminal, the secret must have proxy enabled. (optional) Enable Proxy New Secrets by Default. Type your SSH proxy configuration settings (see Configuring SSH Proxies for Launchers):Įnable SSH Proxy (required to use SSH terminal). Navigate to Secret Server > Admin > Proxying.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |